Home > Audi Tt > Audi Tt Wiper Relay Location

Audi Tt Wiper Relay Location

Contents

Hitting the shafts with a BFH is not recommended - better to hold the end of the actuator arm underneath with a pair of mole grips and supporting the frame with Intermittent wiper function, banging on the dash to make it work, and chattering relays can all be caused by worn switch contacts. Password Register Forgot Password? If any member does this, she/he will be revoked her/his membership forthwith. http://seesbg.com/audi-tt/audi-tt-indicator-relay.html

Got to the point I trust my MGB GT or landy disco Mk 1 more to go anywhere now. If anyone in the past hasn't fitted that plastic trim correctly or a build up of mud is in the locating channel (I kid you not) water can get into the We are working every day to make sure our community is one of the best. There were times when I wondered how on earth the rack would ever come out of the car! #8 A6FanUK, Feb 13, 2008 scottnet New Member Joined: Oct 27, 2008 http://www.ttforum.co.uk/forum/viewtopic.php?f=2&t=157294

Audi Tt Wiper Relay Location

Powered By MyBB , © 2016 MyBB Group. The passenger side bottle top has to be cut down a little as the shaft is shorter, but for a free modification I think these will do the trick and hopefully NineNails Site Moderator Joined: Jun 01, 2003 Posts: 3351 Location: North Wales Posted: Mon May 19, 2008 9:04 pm You should be able to pick up a new linkage assembly for A8 4.2Tdi, 06, Grey/Grey - my new toy - how can a diesel be this fast?

There is (or was, in my case!) a rubber washer/grommet on the top of the motor spindle, which I managed to lose when removing the bracket that holds the motor to Learn More. A new wiper linkage cost £48.56 from Audi (better designed to stop water ingress to the joint) Labour was 1 hour (although the garage only took just over half an hour Audi Tt Wiper Linkage Removal It was starting to bend the mechanism, so looks like I need a new one.

This feature is not available right now. Last edited by EG-4.0TDI; 11-04-2013 at 10:28 AM. However, once you pull the driver side lower panel down, there should be two relay/fuse panels. http://www.vwaudiforum.co.uk/forum/showthread.php/144713-Windscreen-wipers-stopped-working All content is viewed and used by you at your own risk and we do not warrant the accuracy or reliability of any of the information.
Copyright: Images used on this

I have read somewhere you can reset the windshield wiper maintenance option as sometimes its the computer telling you the blades need replacing so they stop working altogether? Audi A6 Windshield Wipers Not Working Both garages advised that a new wiper arm linkage was the only way to fix the problem and save a costly new wiper motor replacement. Sprayed the splines with silicone spray, did the trick for a while. So if your original wipers were faulty and you have fitted a replacement you will not be able to test them until you close the bonnet.

Audi Tt Wiper Motor Replacement

Close Yes, keep it Undo Close This video is unavailable. Better safe than sorry... Audi Tt Wiper Relay Location It's access to information like this that helps so many people. Audi Tt Windscreen Wiper Motor Any recommendation?

Thanks a bunch.I did something that I did a while back on my MG, for better or worse, I sprayed some electronics contact cleaner into the gap around the wiper stalk this content Pretty much the same, yes. For official up to date information on any of there vehicles, please visit the official websites. All fuse ( driver side dashboard) has been check and no fused fuse detected. Audi Tt Wiper Linkage

I attached a fuse location picture. They do it again when turning off the ignition too. Alski. http://seesbg.com/audi-tt/audi-tt-rear-amp-location.html Any recommendation?

Forum software by XenForo™ ©2010-2015 XenForo Ltd. | Showcase ©2015 Quality Add-Ons by WMTech © 2016 WebMachine Technologies, Inc. Tried a few used motors, same problem. I managed to get the entire linkage (plus motor!) out with just a wiggling, sliding motion and some perseverance.

I nearly gave up, and then rotated the linkage part forward and up and pushed the wiper motor back and pulled out the drivers side first and out it came.

I cleaned out both bearings, reassembled with grease, and even replaced the two tiny rubber O-ring seals at the top of each spindle (one was split). Loading... Si. _________________2000/w Audi A4 1.8T quattro Sport Proud sponsor of the snack food industry. Based on the provided information, this sounds like your problem.

Can anyone point me to where they are?! Prob need a wiper motor replacement. __________________ 2010 Q5 premium plus 3.2q 2007 A6 4.2Q 2006 C55 AMG- Sold 2002 allroad Highland green 6 speed- Sold 2006 Audi A3 3.2 S-line- Start News Forum Advertise TTOC Search About TTF Board index FAQ Search Garage Gallery Register Login Board index Information The requested topic does not exist. check over here deviance 9 393 10-05-2016 08:43 AM Last Post: deviance Audi Q5 2009.

Eventually the wipers stopped mid position, and I presume the motor has a safety cut out when it gets overloaded. at least on the A6 the blower fan and MOTOR are directly underneath it. Really clueless and this has been going on for 2 months. NineNails Site Moderator Joined: Jun 01, 2003 Posts: 3351 Location: North Wales Posted: Fri May 16, 2008 7:54 pm Here's a link to help you if it turnes out to be

Too short and the ratchet hits the windscreen, too long an extender and it hits the bonnet. Golf Tdi 03.08 130pd, 6spd, 19k miles - Sold 8th November 2006 - gone to Coventry! Add to Want to watch this again later? I though this may be the bearings in the motor that had rusted but it sounds more like the linkages.

The wiper linkage seizes up. Probably the combination/wiper switch? Typical Audi-esque slow-slow wipers and the occassional stuck-in-the-up-position. Managed to push this out with the ball joint splitter, good clean up with some fine emery paper and packed full of LM grease.

Sorry about the moan. Thank you (12-23-2014 01:14 PM)koossie Wrote: (12-21-2014 05:54 AM)alex2942 Wrote: Dear sir, I really need help on my Audi TT MK2 version on my wiper system. I would STRONGLY recommend you check the mechanism is freely moving before you fit the new motor (that you probably don't need). Fixbook 587,441 views 5:10 Audi engine problems Ticking noise valve cover off 2 - Duration: 1:41.

Watch QueueQueueWatch QueueQueue Remove allDisconnect Loading... aftermarket xenon fitted? I too think it is the switch. Then again it may have just been my car.

Stay safe in the rain and thank you for the feedback. Michael Miller and other Audi Specialists are ready to help you Ask your own question now Share this conversation