Loading... Will cost you around £30 in total from VW. haoudoin 81,282 views 3:04 How to open my hood on A4 B8 Cable broken - Duration: 6:57. Here's a picture to help anyone else who needs a visual to help them out down the line. his comment is here
Fortunately, its not the wire that affects the hood release lever from inside the car. The chrome part as well.Good luck. Is this the lever that I have to pry towards the passenger side? #8 11-29-2009, 09:28 PM moondawg Junior Member Garage is empty, add now Join Date: Jun My lazy self would probably just spray some WD-40 into it. 2002 A4 TQMS Motoza 1+ w/Genesis 380s, 034 HFC, K&N drop-in, 710N, Neuspeed snub, StopTech SS lines w/Hawk HPS, Conti
i pulled too hard and ripped the handle off in my hand.. Sign in 17 Loading... All rights reserved. Just reseating the lever housing cured the problem.
After getting underneath I was able to (blindly fumbling!) just reach and luckily pushed the cable back in. Audi A4 Hood Release Cable Broken These are becoming VERY common now! The bonnet release is a small lever which is part of the catch on the front panel. imp source The end of it appears as a bright white square in your picture. #9 01-29-2010, 09:40 PM asindhidude Senior Member 2004 Audi A4 Join Date: Aug 2008 Location:
Dmitrij Brils 4,676 views 2:06 Audi A4 Window Regulator Replacement | Removal And Installation | - Duration: 9:57. Audi A4 Bonnet Release Handle Broken Thanks in advance for any ideas you all had. to start with.. It will work, but you will need patience. 4.
The chap I spoke to at Audi said that the 1.9tdi was not the worst so I'm hoping for some room once the tray has gone. http://www.vwaudiforum.co.uk/forum/showthread.php/65878-Bonnet-release-catch-not-working Don't think I'm ever going to sell it. Audi A4 Hood Latch Broken Ray Berry 848 views 1:29 Taking off the hood release lever on a car - Duration: 2:34. 2003 Audi A4 Hood Release Handle All content is viewed and used by you at your own risk and we do not warrant the accuracy or reliability of any of the information. Copyright: Images used on this
you'll see the hood latch in front of the radiator with the cable attached to it at the top near the hood, put it on the drivers side edge of the this content Tags: technicalissues newcars engineproblem easeofaccess Like Reply | Report as offensive | Link Thu 25 Jan 2007 20:20 Audi A4 Bonnet Catch - thomp1983 are you sure the cable has broken? Simon Touch 838,547 views 0:55 Loading more suggestions... It's a tight fit, but you can get in there with a 10mm wrench and get those acorn nuts off. Audi A6 Hood Latch Problems
So once you have the top pried open, you can just grab it and lift upwards.Also, while prying, you should use the other hand to pull towards you. Optional I guess, but it kept my hands clean and scratch free.I forgot to mention that the black grill has no catches at the bottom. Tastefully Modded, Untastefully Stolen. 2001 1.8tqm Avant. http://seesbg.com/audi-a4/audi-a4-ac-compressor-not-turning-on.html FaZe Brawler r 26,765 views 5:48 AUDI 100; Broken Hood Latch: How to open(English) - Duration: 11:25.
To start viewing messages, select the forum that you want to visit from the selection below. 2005 Audi A4 Hood Latch Working... Release Hood latch from mechanism, and reattach to hood. 5.
Thanks for all the advice. Sign in to add this video to a playlist. Your grill will pop out and you can see the hood latch and cable. 2002 Audi A4 Hood Release Cable The above method might be for is the cable breaks?
If not, luckily I topped up my warranty the other day... Anyone have a trick on getting the release to work? richpin06a 409,844 views 2:10 Open Car Hood - All Cars - Duration: 2:07. 2CarPros 158,620 views 2:07 Battery Replacement on Audi A4 B6 .How to remove and replace the Battery AUDI check over here Close Yeah, keep it Undo Close This video is unavailable.
Alternative fix! (not long screwdriver method) I had it happen on a car I did a t-belt on and I just removed the belly pan, reached up and released it. I went ahead and cleaned up the mechanism while I had it removed. I really am hoping to get this fixed without having to spend an arm and a leg! -WB 09-14-2010, 11:16 AM #2 mmazerolle Audi Forum - Posts like an Some XenForo functionality crafted by Audentio Design.
there isnt no way your get up there with a screw driver from underneth see the mech you need to push down wards were that bar is in the above picture, I have searched the forum and couldn't find anything so forgive me if this has already been discussed. Get the front of the car up on ramps or jack stands. Any help would be greatly appreciated.